Trade In & Save!
Get up to $500 for trading in a qualified 600 MHz Band wireless system!
- - Offer Expires 04/30/18
- Download rebate
Interchangeable cartridges let you change its pickup pattern.
The Shure MX185 is a wired Lavalier electret condenser microphone designed for speech and vocal pickup, general purpose sound reinforcement, recording, and remote monitoring applications. It can be clipped to neckties, lapels, and other articles of clothing. The MX185 Lavalier microphone features a cardioid microphone cartridge and provides good rejection of ambient noise. Includes belt-clip preamp, rotatable tie clip, dual tie clip, and snap-fit windscreen.
Consumer Alert:Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCCs wireless microphone website at: www.fcc.gov/cgb/wirelessmicrophones.
- Flat frequency response across the vocal range for uncolored sound
- Interchangeable cardioid, supercardioid, and omnidirectional cartridges that provide optimal choice for each application
- Sleek, low-profile design for unobtrusive appearance
- Balanced, transformerless output for increased immunity to noise over long cable runs
- Advanced RF filtering
Order today for Shure quality at an affordable price.
MX185 Microflex Lavalier Microphone Specifications:
- Type: Condenser (electret bias)
Frequency Response: 50 to 17,000 Hz
Polar Pattern: Cardioid
Pickup angle: 130 degrees
Output Impedance: EIA rated at 150 ohms (180 ohms actual)
Open Circuit Sensitivity (at 1 kHz, ref. 1V/Pascal*):-35.0 dB (17.0 mV) All settings -12 dB at 0 gain *1 Pascal = 94 dB SPL
Max SPL: (1kHz at 1%THD, 1 k ohm load): 124.2 dB All settings +6 dB at 0 gain
Equivalent Output Noise (A-weighted): 28.0 dB
Signal to Noise Ratio (referenced at 94 dB SPL): 66.0 dB
Dynamic Range at 1 k ohm load: 96.2 dB, 100 dB at 0 gain
Power Requirements: 11 to 52 Vdc phantom, 2.0 mA
Common Mode Rejection: 45.0 dB minimum
Polarity: Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector
Environmental Conditions: Operating Temperature Range: -18 to 57 degrees C (0 to 135 degrees F); Storage Temperature Range: -29 to 74 degrees C (-20 to 165 degrees F)
Cable: Shielded 1.2 meter (4 ft.) cable terminated with a 4-Pin Female Mini Connector (TA4F)
Dimensions (length x diameter): 3.89 " x .79" (99 x 20 mm)