Massive power and limitless possibilites in one tiny head.
The Kemper Profiler was designed to be a complete solution for all your guitar playing needs. You can use it just like you would a regular amplifier, or you could use it as a multi-effects unit, or even as the front end for your guitar-based studio.
Nearly all digital guitar amps available today offer the same features-simulations of classic and modern guitar amplifiers and stomp boxes, usually with some digital and studio effects thrown in for good measure. The Kemper Profiler doesn't simply include digital versions of guitar amps, but lets you make a "profile" of your own guitar amp to use inside the Kemper Profiler. You can also load profiles of other guitarists' amps into your Kemper Profiler.
If you want a more technical description: the Kemper Profiler analyzes the sonic characteristics of a reference amplifier. This process allows it to faithfully recreate the characteristic sound of virtually any guitar amp, and adopt the behavior and interaction of the components of the analyzed amplifier.
The Kemper Profiler doesn't just capture the sound of your guitar amp alone; you can also capture the sound of the cab and the mics (including the mic distance and angle). You can store 1000 amp profiles in total and it comes with 30 different stompbox effects as well as a master effects section with master delay and reverb.
Profiler Remote is the quintessential foot controller for your Profiler. Kemper spent a tremendous amount of time to create a versatile and yet easy to operate floor board. The tight integration in between Profiler and Remote allows you to control, administer and program without any knowledge about MIDI or delving through cryptic data sheets.
The large, illuminated display is designed to be looked at from a distance and Remote's housing is built like a tank. Just what the doctor orders for touring musicians on dark stages.
Five buttons allow you to directly access five different programs ("Rigs") and entire performance programs can be switched using a bank system. There are dedicated buttons to access the tuner, tap tempo in and enable the new, exclusive Looper Effect.
Remote connects via a single Ethernet cable to your Profiler. No extra power supply in needed and the included cable is 7 meters long (21ft). Longer cables are possible as well.
Up to four continuous foot pedals can control multiple parameters inside your Profiler. Four buttons switch of stomps and effects. The programming required is easier to learn than putting a new contact into your cell phone. Click to choose, assign, done.
- Maximum power: 600W (solid state)
- Modeling head
- Two inputs
- Controls: noise gate, mod rate & intensity, delay feedback & mix, reverb time & mix, master volume, gain, channel volume, four-band EQ, mode select, type select
- Impedance: 4, 8, 16 ohms
- Direct output
- Headphone output
- XLR stereo output
- Monitor output
- 1/4" stereo output
- USB-A and USB-B ports
- MIDI thru, out and in
- S/PDIF in and out
- Ethernet port
- Built-in tuner
- Two 1/4" TRS switch/pedal for mono/stereo switch or expression pedal
- Remote 14-button footswitch included
- Dimensions: 14.8" x 8.5" x 6.8"
- Weight: 14.3 lb.