A lavalier suited for location work.
This Shure Performance Gear PG185 is an electret condenser cardioid microphone for clip-on use with a wireless bodypack transmitter. The PG185 TQG has an acoustic windscreen that minimizes wind noise in outdoor applications and a clothing clip for secure placement. Shure microphones deliver legendary sound quality, stage-proven durability and hassle-free setup for worry-free performance.
Consumer Alert:Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCCs wireless microphone website at: www.fcc.gov/cgb/wirelessmicrophones.
- Clothing clip for secure placement
- Acoustic windscreen minimizes wind noise in outdoor applications
- Reliable at temperature and humidity extremes
Shure quality at an affordable price. Order today.
PG185 TQG Condenser Lavalier Microphone Specifications:
- Type: Condenser, electret bias
Frequency Response: 60Hz to 12,000Hz *
Polar Pattern: Cardioid (unidirectional)
Output Impedance: 1200ohms @1kHz*
Output Level; -47dBV/Pa (2.5 mV) *
Signal to Noise Ratio: 66dB, 1kHz at 1 Pa*
Maximum SPL: 120dB
Dynamic Range (max. SPL to A-weighted noise level): 92dB *
Output Noise: 28dB (typical, A-Weighted) *
Recommended Operating Voltage: +5VDC, 10V max (pin 2 to pin 1)
Polarity: Positive sound pressure on diaphragm produces positive voltage on pins 3 and 4 relative to pin 1 (ground) on the mini TA4F connector.
Cable: 48 in" (1.22 m) two-conductor shielded
Connector: Mini TA4F
Net Weight: 0.81 oz (23 g)
*All measurements taken using RK183PK preamp set to 0dB gain