Behringer ULTRA-DI DI400P Passive Direct Box
Sku #182498000000000 Behringer 182498 YFD Direct Boxes https://www.esnapw.com/rses/ESnapServlet?MerchantNumberSent=63655- Write a Review
- Seen a Lower Price? Click Here.
FREE SHIPPING on Almost Everything
The Behringer DI400P Passive Direct Box lets you connect instruments or amplifier outputs to your mixer. The Ultra-DI converts any unbalanced signal to a balanced signal and eliminates unwanted noise. With its high-performance transformer, the Behringer Ultra-DI also allows you to use very long cables without the loss of high frequencies.
Features
- Connects your guitar or bass directly to your mixer without losing tone due to impedance mismatches, long cables and cycle hum
- Converts any unbalanced line-level signal to balanced mic-level output
- Provides impedance and signal matching for the direct connection of instruments to amplifiers and mixers
- Allows the use of long cables without losing high frequencies
- Thru/Out jack lets you send the unbalanced signal to an onstage amplifier while the balanced signal is routed to the mixer
- Ground lift switch eliminates typical ground loop problems such as hum
- High-performance transformer for ultimate signal integrity
ULTRA-DI DI400P Passive Direct Box Specifications:
- Frequency response 40 Hz (-3) to 20 Khz
- THD +N (distortion) 0.0007% @ 1kHz input level +dBu
- Input 1/4" TS (unbalanced)
- Level change (input to output) -20 dB
- Output Balanced
- XLR
- Impedence ratio (input to output) 110:1
- Dimensions (HxWxD) 1.4" x 4.7" x 2.6"(35mm x 120mm x 66mm)
- Weight Approx. 0.44 lbs (0.02 kg)
REVIEW SNAPSHOT®
by PowerReviews(based on 1 review)
Ratings Distribution
REVIEWS
Reviewed by 1 customer
Displaying review 1
Comments about Behringer ULTRA-DI DI400P Passive Direct Box:
Decided to try a Low-Z connection with XLR connectors from my effects pedals to the mixer to see if it be better than using the High-Z TRS connectors. The Behringer ULTRA-DI DI400P Passive Direct Box was the least expensive product offered. But it is metal and seems well constructed and it works fine. The first noticable advantage is that with the longer low-z cable I can easily run the cable off to the sides of stage set-ups. Getting the cable off to the side means less duct taping when the cables are stretched out. I haven't noticed much difference in the sound quality but low-z is typically a better signal.
Displaying review 1
