Pro Co Solo Distortion Guitar Effects Pedal
Distortion & Overdrive Effects Pedals
- Write a Review
- Seen a Lower Price? Click Here.
FREE SHIPPING on Almost Everything
The 100% analog Solo is no one-trick pony.
Although it is housed in the same indestructible and road worthy steel enclosure that has come to be a trademark of Pro Co stomp boxes, the Solo distortion guitar effects pedal marks a departure from the RAT series of pedals in more ways than just its cosmetics. With its enormous range of tones, 3-way selectable clipping modes ("hot, melt, & burn"), and highly interactive "scoop" and "tone" controls, the Solo just might be the most versatile pedal in your arsenal.
The Pro Co Solo Distortion pedal is equally at ease in both lead and rhythm capacities, and with a wide variety of amplifiers and guitars. Capable of going from vibey, chewy, warm low gain tones, to deliciously mean and crushing high gain tones, the Pro Co Solo pedal still remains remarkably true to the sound that matters most: The sound of you and your guitar. And speaking of staying true to the sound of your guitar, true-bypass switching ensures that when the guitar pedal is off, there is no coloration of your sound.
Even in its highest gain settings, the Solo remains extremely tube-like, articulate and touch sensitive. Complex chords ring out with clarity, leads sustain with ease. Roll back your volume knob and it cleans up, just like a good tube amp would.
The Solo effects pedal uses three pairs of carefully matched (or should we say, carefully mismatched) clipping diodes to produce asymmetrical clipping. The three pairs are accessible via the "hot, melt, burn" slider switch. This has the effect of making the Solo clip very much like a tube amp going into natural power tube distortion.
Pro Co Sound has been building professional effects since 1979. Since then, the RAT has evolved from a single, hand-built prototype into a family of versatile distortion pedals.
- Hot, Melt, Burn Slider switch
- Distortion, Scoop, Tone, and Volume controls
- 100% analog signal path
- Pro Co's classic, virtually indestructible steel enclosure
- Heavy-duty, industrial footswitches, knobs, and jacks
- On/Off LED indicator
- Sloped face for easy stomping
- Glow in the dark graphics
- Military-spec glass-epoxy circuit board
- AC jack (RPS-1 power supply sold separately)
- "No tools required" battery compartment (9 volt not included)